Left Tool Bar

Once the detection and measurement options are set and saved, run the Measure > Measure command. The measurement will be performed and the results will be written to the Data table. The detected grains will be indicated inside the image. Since the automated system can make mistakes, it is required to confirm the correctness of each measurement. Use the following tools (placed on the left toolbar) for corrections:

Separate

Use this tool to separate graphite manually if some of the grains were detected incorrectly. It is recommended to increase transparency of the binary layer so the object borders become more obvious.

See Binary Layer Color and Transparency.

Connect

Creates a connection between two neighboring graphites. Draw the connection by mouse.

Delete

Deletes continuous areas of the binary layer after they are clicked on.

Show Mask

Displays / hides the vector test mask. If the mask is moved before the measurement results are accepted, the image is re-measured according to the new placement of the mask.

Show Labels

Displays labels within the image.

Measure Cast Iron

Runs the Cast Iron measurement.

Options

Opens the Cast Iron Options dialog window.

General

Here you can turn on the option to Show message box for confirm the 'save' action in measurement and detection settings and optionally switch to the JIS G5502-JIS nodularity calculation method.

Labels

Sets parameters of the labels such as the font type, font size, background color and bounding rectangle color.

Export

User can check which options are being exported to the report and which are burned into the image.

Toolbar Setup

Executes View > Customize Toolbar > Setup .

Finish Measurement

Saves the current measurement results to the Data table. The system becomes ready to measure the next field (image).

Skip Measurement

When measuring a sequence of images, this button discards the results of a single measurement.

Cancel Measurement

Discards results of the current measurement.

Left Tool Bar🔗

Left Tool Bar