MeasureThis button executes the concrete measurement. At first a wizard appears where the Measurement name has to be filled. A new directory with this name will be created in the shown Report directory. The measurement report will be saved to this directory. It is required to insert a unique measurement name in the scope of the Root directory otherwise the wizard will not proceed.
Note
Please, do not use “test” as the measurement name. It is reserved for testing purposes. The reports in the “test” directory will be overwritten without notice.
After the measurement name is inserted, click to start prefocusing on the concrete sample. You will be prompt to focus manually (if the three-point prefocus is selected, you will need to focus three-times, see Focusing in the Measurement tab in 
Options). The focusing can be done by the mouse wheel or by the joystick wheel. Click and confirm the calibration of the document by clicking . Then the Measurement progress window appears. Information about the measurement progress is displayed on the left. The top bar shows the task progress in the scope of the current concrete sample and the bottom bar in the scope of the whole measurement.
Figure 346.
Save current image... Saves the current image to a .jpg file.
Refresh detection Refreshes the current detection.
Focus manually... Manually focuses on the current measurement step.
Previous step Moves to the previous step in the measurement sequence. It is enabled only if the 
Pause button is pushed.
Stop Finalizes the measurement and creates a report.
Pause Pauses the automatic measurement.
Go Starts the automatic measurement.
Next step Moves to the next measurement step. It is enabled only if the Pause button is pushed.
Keyboard shortcuts used while measuring:
Next measurement field - secondary mouse button.
Previous measurement field - Ctrl + secondary mouse button.
Measure air void - Middle mouse button.
Delete air void - Ctrl + middle mouse button.
Delete air void part (classic method) - Primary mouse button.
Delete air void part (CAD system method) - Primary mouse button (left to right).
Define air void (classic method) - Ctrl + primary mouse button.
Define air void (CAD system method) - Primary mouse button.